This is a discussion on What jacks, stands, ramps do you use to lift your car? within the Veloster Maintenance forums, part of the Veloster Turbo Garage category; Quick jack portable hydraulic lift. Comes in 4 different lift weights and sizes. Nabbed the 5000 lb lift in a group buy off another forum. ...
Last edited by Incognito; 11-07-2018 at 09:10 AM.
Good lord I'm stupid, can't believe I haven't figured out to just drive up on boards to get an extra few inches to get my jack under the center of my car. My garage is SUPER cramped (2 car garages with a center divider are a joke, even my tiny ass car barely fits) and sometimes i can't fit a jack on one side to lift it up from left to right.
Also those quick jacks do look super nice, might have to try investing in a set eventually/buy used/group buy etc.
2016 Vitamin C MT
CCG front grill mesh
SXTH front crossmember
Pierce rear torsion bar
Pierce VT-One Strut brace
K-Sports all around
SXTH short ram
Anyone else afraid that rhino ramps will just crack and explode into shatters?
Nope love the rhino ramps.
2012 Boston Red Veloster NA Base Manual BTRcc tuned 167whp / 138wtq SOLD! - TK.COM CAI/catback - Nameless poly motor mount - BTRcc 89 octane tune
2014 Vitamin-C Veloster Turbo Base Manual
K&N panel filter - Nameless poly motor mount - Curt hitch - CF filler cap - Hawk ceramic pads - PMS torsion bar - UNIQ front strut bar - DZIII tires
2001 Emerald Green Kia Rio Manual
Overhauled suspension - H&R springs - 1Gb control arms / torsion rods - A6D 1.6L DOHC swap complete!
Pittsburgh low profile jack and also Rhino Ramps.
The rhino ramp is rated for 3k lbs. The VT will be lucky to have 1k lbs per corner.
'15 Auto VT
PB's with slips and video:
1/8 8.752 @ 85.68 MPH
1/4 13.421 @ 105.57 MPH