Veloster Turbo Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Veloster Turbo Problems / Help
    I’ve had a p2261 code for a while now and since then I’ve installed a new Bov, new wastegate and Bov solenoid and have checked all my hoses and fittings. It was fluttering until I replaced my wastegate solenoid and now it just won’t let me build over 10 psi boost. The engine and turbo are good...
  2. Veloster Turbo Discussions
    Hey guys, I need some input here. Driving for the past 2 days I've noticed that my car will go into limp mode when holding the petal at 50% and more commonly when going uphill, causing a loss of boost and throwing a (P0299) code. I'll pull over and my car will be fine after turn it off and...
  3. Veloster Turbo Discussions
    Hello! I have recently bought a boost gauge for my 2015 VT and i am looking to tap into a vacuum line in order to get readings. Which line would work the best for what i am trying to accomplish? I have seen other threads saying to use the line coming directly from the top of the throttle body...
  4. Veloster Turbo Problems / Help
    Hi, so I tapped in a boost gauge on this line, however I did it a little low, so I need to buy another. It's the line that goes into the throttle body, and has a valve on the middle of it. What is it called?
  5. Veloster Turbo Problems / Help
    So I have a 2016 VT. resonator delete FMIC Short ram intake Cat back exhaust BOV I have a down pipe but not installed. I have been running this setup for almost two years and have not had a issue at all. This last week I started having issues when I get above 3,500 rpm’s. Gauge maxes out, start...
  6. Veloster Turbo Problems / Help
    I've been having an issue with my TurboXS SML not being able to hold boost and leaking while higher up in the rpms. I was thinking of just switching to a stronger, more resistant spring inside. I've been trying to look for someone else on the forums with the same issue but have had no luck, I've...
  7. Veloster Turbo Problems / Help
    [SOLVED] My Exhaust is Haunted. HELP! UPDATE: Took it back into the shop and got it up on the lift. After much searching, we found a small 2-3mm area where the weld hadn't completely sealed the pipes in the fabricated section of the exhaust. He cut off the whole section and put together a new...
1-7 of 7 Results
Top