Veloster Turbo Forum banner
rear camber
1-2 of 2 Results
  1. Veloster Turbo Discussions
    So today, as I was adding washers behind my hub for camber, I ran into a brake clearance issue. I have 4 washers doing like -5 or -6 degrees of camber. Also, I was told to add an additional washer in the bottom front of the hub to combat the toe in. The hub spins freely when the brake calipers...
  2. Veloster Turbo Discussions
    So I was removing the rear hub to attempt to add washers for rear camber, when I stripped the Phillips head. What are my options to get it out? Just to drill? Also, it was only supposed to be torqued down to like 5 lb ft. What could have caused the screw to be so tight? Should I tighten it down...
1-2 of 2 Results
Top