You can't. Not and get a good reading. Got to get TSs manifold adaptor plate.
Sent from my iPhone using Tapatalk 2
Sent from my iPhone using Tapatalk 2
Boost gauge help!!!
I just got a boost gauge and a single pod a pillar. I have the lighting looked up on the gauge but not the vacuum hose. Can somebody please tell me where I need to tap into under the hood with the t fitting. Please post a picture if possible thank you!
1 - 11 of 11 Posts
What is that TS thing?
Isn't there a vacuum hose that comes off the blow off valve under my CAI?
The hose ahead of the BPV solenoid has been shown not to accurately convey boost information. The vac lines on our little engine are oddly unhelpful.
This is the TS manifold adaptor to which I was referring.
Sent from my iPhone using Tapatalk 2
This is the TS manifold adaptor to which I was referring.
Sent from my iPhone using Tapatalk 2
If I want to use the set up that I have now for the time being where can I run it? The reading doesn't have to be 100% accurate just as long as it's reading in the boost side and not just the vacuum
Have you looked into the Torque App? It will provide you will a ton of info including boost.
Just mounted the gauge and tapped into the hose off of the blow off valve. Works great!!!
Well done sir!Just mounted the gauge and tapped into the hose off of the blow off valve. Works great!!!
Thanks Jon!!!!!
1 - 11 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Veloster Turbo Forum
This is the Veloster Turbo forum where you can learn all the tips and mods to make your Hyundai Veloster Turbo faster and talk about the new Veloster N!
Full Forum Listing
Top Contributors this Month
View All
RPW00Mirage
39 Replies
L3g10n
17 Replies
AnxiousBlue
11 Replies
Recommended Communities
