This is process one out out two…
Due to the fact we are maching a stainless steel surround for the opening and the I will adhere a fine chrome mesh inside it.
IF ALOT OF PEOPLE LIKE IT I WILL PRODUCE THE SURROUNDS AND WORK OUT A GOOD PRICE!
This is process one!
Use a door pull tool as shown its easy this way to take those clips out
Then you should see the underside of the vent... use a 10mm and push it out to direction of the window.
Just what it looks like
Next i placed the vent over the back side of the heat shield thing ( you will see two round spots on the left and right side this is where the two bolt locations are for the vent so use it as a center point like i did). Then trace it out and cut it with a razor.
Ounce cut it look like this, i used a lighter to melt some of it back down.