[Retsolev]

Hey guys, just figured I'd share these with you all:

New Magnaflow:

Inside Engine Bay:

Making sure the suction cup works:

I'm going to be shooting some more, I shot these with the case on. Apparently if you're !100mph then you should not use it because it hinders sound quality.

If anyone else has some sweet GoPro shots post-em!

 

[Petey T]

Intake?

 

[ELS]

Did you go over any bumps with the pro? I'm afraid bumps will make the camera fall.

 

[Blakngold4life]

Did you go over any bumps with the pro? I'm afraid bumps will make the camera fall.

I have used mine during many autox, and multiple track days with speeds over 100mph. Never had or seen a failure from the suction cup in person.

 

[swordfish]

Did you go over any bumps with the pro? I'm afraid bumps will make the camera fall.

You can also attach an fail-safe lanyard as well. But the suction cup isn't you little dinky, 'connect my GPS to the windscreen' jobbies.

 

[Petey T]

I've had one mounted to a Ferrari challenge car at Daytona on the high banks at 160+ mph. They're rated to something like 200 mph but all of those twin turbo Lambo guys have them on close to 250mph. As long as the surface is clean, smooth, and fiberglass/carbon they'll stick just fine

 

[Darkhill240]

They ink time they usually fail is if they get hit. The mount gives before doing damage to the camera. It saved mine at a drift course before.

 

[Retsolev]

The only way these things are going to fall off is if you slam it into something, and even then I'd be surprised. Just mount it on a flat panel as bends could let air break the suction.

 

[KKaWing]

Apparently if you're !100mph then you should not use it because it hinders sound quality.

vvv For the wind noise: