[str8maxn]

Hello All,

I am new to the form and I just picked up a wrecked 2016 Veloster turbo. Part of the harness on the right side of the engine was ripped from the hit. I need to figure out what 18-20 wires go to.
I know I need the following wire colors for:

Window Washer pump - 3 wires
Window Washer low level fluid - 2 wires
Right side Fog light - 2 wires
Horn or Horns - 2 \ 4 wires... Does the veloster have two horns?

Also, does anyone know what these two plugs \ things do? They are located dead center and low near the of the car.

 

[christobevii3]

Single horn with two wires. Horn is connected with plastic disconnect.

The other picture i believe is the ambient temperature sensor

 

[str8maxn]

Do you know the colors of the wires for the horn ? Black & ?

 

[christobevii3]

Nope and didn't test mine after switching. Use a multi meter?

 

[bcraig70]

I hope this helps you out

HORN
Black and grey wire, single horn

PUMP

FOG LIGHT

SENSORS

 

[str8maxn]

This is just what I was looking for, Thank you very much BCraig70.


Only 6 more wires to go...

 

[str8maxn]

Does any one know the color wires for the Washer Fluid low level sensor? I believe its 2 wires.

 

[trdtoy]

2 wires to each temp sensor, 2 to the horn, 2 to fog light, and 8-10 to the washer tank.

How many total and what color are they so we can do process of elimination? Clear pic of all the wires in question will help as the pic posted is unclear and wires tangled everywhere.

Also keep in mind there could be color variance from car to car. Also some of same color are used as well so trace back to ecu and use an ecu pin out will be your best bet.

 

[str8maxn]

Hello all,

I was able to sort out the following:
Horn (2 wires)
Washer pump (3 wires)
Fog Light (2 wires)
Sensor 1 ( 2 wires Blue \ Black)
? Sensor 2 ( 2 wires Blue \ Grey) I don't know how to test this Sensor to confirm its the correct grey wire or what this sensor does.Does anyone know?

I need the low washer level plug (2 wires).. I didn't have time to test this one today.
and one other set of wires I have no clue that they go to.

Left over wires are :
Light Grey
Grey with black strip
2 black wires (grounds)

Any idea what they can be?

Thank you all for the help..

 

[trdtoy]

Lower washer plug has 5 wires in one plug, 3 of which shared with upper plug, and 2 different ones. Then another plug down low has 2 wires I think going to it.

 

[str8maxn]

Lower washer plug has 5 wires in one plug, 3 of which shared with upper plug, and 2 different ones. Then another plug down low has 2 wires I think going to it.

trdtoy, Yours must be different, Mine has 2 separate plugs 3-wire for the pump and 2 - wire for the low washer level. From what I can tell.

Here is the main pump plug.

Here is the low level plug.

 

[str8maxn]

Hello All,

I need some help. I think I found the missing set of wires... They appear to be an Air Bag sensor that's located on the lower right side. It appears to be attached to the Window Washer reserve tank.

If someone could check the number and color of the wires ... It would really be greatly appreciated. Here is a pic...

 

[str8maxn]

If anyone can also get a part number for that Air Bag sensor that would be great.

 

[trdtoy]

Here is what's on my 15 VT after the headlight section branches off.

 

[str8maxn]

TRDtoy.... Thank you for the pic's . Can you please provide a general idea of each plug location or a list of what each plug is?

I am really interested in the plug that attaches to the outside of the Washer Fluid reserve. The Air bag sensor.

 

[trdtoy]

Here is what's on my 15 VT after the headlight section branches off.

View attachment 97858

View attachment 97866

View attachment 97874

View attachment 97882

View attachment 97890

View attachment 97898

View attachment 97906

View attachment 97914

Hood switch. 2 wires. Front corner under hood on right side.

Airbag/impact. 2 wires. On frame beside washer reservoir.

Top of pump. 3 wires. Shared with connector on bottom.

Bottom of reservoir. 5 wires. 3 shared with top pump plug. 2 shared with low fluid sensor.

Low fluid switch. 2 wires shared with bottom plug.

Horn. 2 wires

Temp sensor 1. 2 wires.

Temp sensor 2. 2 wires.

Fog light. 2 wires.

 

[str8maxn]

Hello Everyone,


Thank you guys very much... I was able to sort each wire and everything is working as expected. No check lights anymore.


Here is a pic of what I am working with. I am ready for paint and I hope to have the Veloster on the road soon.

 

[str8maxn]

Hello all,

Just wanted to say "THANK YOU" for the help. Here is what the final outcome of the rebuild looks like. My son and I did all the work; I am happy with the results.

I have a few questions...

1. When I shut the car off, I hear a clicking sound for a few seconds. Is this normal?
2. It seems like the idle may be a bit high, with the AC on the highest setting, the car idles a t 950-1000 RPMs. Is this normal?
3. Car seems to have a harsh take off vs. a smooth gradual acceleration. Could this be due to the high idle or is this normal because of the dual clutch?

 

[RPW00Mirage]

Yes
Seems OK
Maybe.