Veloster Turbo Forum banner
1 - 20 of 37 Posts

·
Registered
Joined
·
870 Posts
Discussion Starter · #1 · (Edited)
Ok guys!!
I have been getting a few responses for the Sequence Bumper Claws and have these in stock and ready to ship:)

Price is $70 shipped:)

These are made from HIGH Quality ABS Plastci and uses 3M Backing Stick plate:)

OK GUYS YOU CAN ORDER HERE:)

http://uniqperformance.ca/products-page/exterior/1405-2/
 

Attachments

·
Registered
Joined
·
870 Posts
Discussion Starter · #4 ·
They dont come Painted and most people just leave it Black looking...

Here is a picture of what they look like
 

Attachments

·
Registered
Joined
·
870 Posts
Discussion Starter · #12 ·
Its hard to explain but when you install and stick it on you can actaully feel the spot it goes without having a gap:)
Its not hard at all!!
 

·
Vendor
Joined
·
3,541 Posts
yeah, I installed these and was confused at first. After looking at pics and putting them up to the bumper you pretty much know where they go. On the other hand, the bumper claws fitment on the VT is a little off and it even shows on the Sequence turbo car. Still look pretty good but up close there it a gap.
 

·
Registered
Joined
·
55 Posts
i have seen these for sale on another website... not going to say where... for like 110-130 bucks.. depending if you want them painted or not
 

·
Registered
Joined
·
128 Posts
Funny how such a small thing can so drastically improve the looks. I will own a set.

FYI, this price is WAY better than what I've seen them quoted for from another site.
 
1 - 20 of 37 Posts
Top