Veloster Turbo Forum banner
1 - 2 of 2 Posts

·
Registered
2015 RB Accent-not so stock 🤫
Joined
·
737 Posts
Discussion Starter · #1 ·
Anybody have the specs on the torque for the clamp holding the turbo to the manifold?
I just put mine back together after getting the manifold back from jethot but there's no info I could find in the service manual or here on the forums.

It's the V-clamp holding the turbo to the exhaust manifold.
 

Attachments

·
Registered
2015 RB Accent-not so stock 🤫
Joined
·
737 Posts
Discussion Starter · #4 ·
Should be same or similar tq spec as any other bolt with 10 mm head on the car since that V-band nut is 10 mm.
I'll keep that in mind.
I didn't pay attention to how tight this nut was when I removed it. My bad. 🤦
Thanks all. 🙏👍
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top