[shaftx0717]

I just noticed that the front right side(front passenger) of my VT is a quarter inch higher. Is it normal or should i call the dealership to fix this??? By the way, the car is a month old and has 2.9k miles on it. TIA.

 

[ptrsracing]

definitely not normal unless you weight a ton or two, drive to dealership for a check since its still under warranty

 

[shaftx0717]

Thanks for the advice. Ill post some pic tomorrow. I need your feedback guys about my problem. TIA.

 

[lagonwagon]

If I'm correct, our gas tank sits center line, so it can"t be that. My 07 Grand Cherokee's tank was on the drivers side, so the emptier the tank got the higher that side rode.

 

[MyDianaZ06]

Make sure you are looking at it on a even level road.

 

[shaftx0717]

Heres's the problem of veloster that im talking about.To all VT forumers, did you guys also check if the height of your veloster is even or not??? TIA

Even from the rear i can tell the height of my car is uneven.

 

[lagonwagon]

Nothing to worry about there, you're car's just a PIMP! That's textbook gansta lean!

On a serious note, have you measured it to get 1/4 inch because it looks like more than that. That would drive me crazy. I don't believe mine is like that or I would have noticed but I will measure the corners when I get home.

 

[lagonwagon]

Maybe it's trying to get away from the FRS you parked next to.

 

[shaftx0717]

Dont tell me our veloster are scared to BRZ???lol.

 

[UHF3]

That definitely looks a bit off. Is that a Chinook behind your car????

 

[shaftx0717]

Yup, its a CH-47(Chinook helicopter).

 

[lagonwagon]

Dont tell me our veloster are scared to BRZ???lol.

Nah, probably just snapped the pic right before your VT was going to lift it's leg and show the BRZ what it really thinks of it. I'm just hate'n. I wouldn't be on this forum if the BRZ had a functioning back seat and a third door.

 

[ynggun]

You rear plate is also mounted to one side

 

[The Mackies]

Nah, probably just snapped the pic right before your VT was going to lift it's leg and show the BRZ what it really thinks of it. I'm just hate'n. I wouldn't be on this forum if the BRZ had a functioning back seat and a third door.

same I really need 2 usable back seats, dang kids lol

 

[lagonwagon]

So I measure the four corners from the ground, through the center of the wheel to the bottom of the fender. I did not take into account tire pressure.

Passenger Front = 26 5/8 in
Rear = 26 3/8 in
Drivers side Front = 26 3/8 in
Rear = 26 3/8 in

Findings show that mine too rides a bit high on the passenger side, but only in the front.