Veloster Turbo Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi there, new to the forum, have a 2013 VT Auto. Changed my map sensor today from the old part number one to the 39300-84400 one. Smoother accelerating etc. now. Quick question though, did anyone notice a slight increase in engine noise under load after installing? Thanks
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
It will only benefit the car if the other one went bad or was not clean. I believe 3 part numbers were made for the sensor and all will operate the same. None of them will cause any increased engine noise.
Okay, my old one was a little oily but kept it clean, might swap back in to see if the noise disappears, could be a faulty sensor. Thanks
 
1 - 2 of 2 Posts
Top